SUB6
The SUB6 as been designed to complete and achieve a really High Standard Full Range Line Array in combination with DLA10 or DLA10W Line array cabinets. The SUB6 is composed of two 18” low frequency ND cone drivers mounted in a manifold configuration. The complex elliptic bass reflex design reinforces the bass in order to achieve a flat frequency response down to 35Hz. Mainly developed for Line Array purposes, the SUB6 will fit perfectly any application where a large bass reinforcement is needed.
- 35Hz cut-off frequency
- Optimal LF coupling
- PC remote controlled
Keep empty
Frequency response (1): 35Hz - 150Hz
Power handling: 2 x 1’200 W (AES) (4)
Maximum SPL peak (2): 140dB
Low frequency : 2x 18" inch, ND ferrofluid cooled, long excursion, low distortion cone driver
Nominal Impedance: 2 x 8 Ohms
Connectors: 2 x Neutrik Speakon NL4MP (wired in parallel)
Cabinet Size (WxHxD): 728 x 586 x 980mm
Cabinet finish: Black epoxy painted
Rigging: EasyFlighing AP rigging system for DLA10
Protective grill: Removable hex. perforated 1,6mm steel, foam cover inside
Weight: 95Kg
- DLA10-amp
- DLA10
- DLA10W-amp
- DLA10W
- AP44M20
(1) Frequency response: +/- 3dB, measured at 3 meters, on axis, half-space conditions - MLSSA 1/3 octave
(2) Max peak SPL: Measured with music referred to 1 meter
(3) Crossover: Acoustical crossover frequency - at these frequency, transducers produce equal sound pressure level
(4) AES: Power handling is measured under AES standard conditions
(5) Power AMPS: Amplifier RMS output power per channel into 2 ohms, both channel driven