SUB6-amp

The SUB6-amp as been designed to complete and achieve a really HighStandard Full Range Line Array in combination with DLA6 Line array cabinets. The SUB6-amp is composed of two 18” low frequency cone drivers mounted in a manifold configuration. The complex elliptic bass reflex design reinforces the bass in order to achieve a flat frequency response down to 35Hz. Mainly developed for Line Array purposes, the SUB6-amp will fit perfectly any application where a large bass reinforcement is needed.

Key features 
  • Self powered
  • 35Hz cut-off frequency
  • Optimal LF coupling
  • PC remote controlled
Specifications 

Keep empty

Acoustical 

Frequency response (1):  35Hz - 150Hz

Maximum SPL peak (2):   140dB

Transducers 

Low frequency :   2x18" inch, ferrofluid cooled, long excursion, low distortion cone driver

Amplifiers 

AMPLIFIER 1 (SUB)
Output power (5):   2'500W RMS
THD, DIM, SMPTE:   <0,05%

AMPLIFIER 2 (DLA6)
Output power (low) (5):   1'250W RMS
Ouput power (high) (5):   1'250W RMS
THD, DIM, SMPTE:   <0,05%

Audio Input 

Type:   Analog Differential balanced input circuit

Connectors:    Female XLR; Male XLR loop

Nominal impedance:   10K Ohm

AC Power 

Connectors:   Female PowerCon, in; Male PowerCon loop

Input voltage:   115V - 230V nominal +/- 10%

DSP 

Sampling rate:   96 Khz

Basic delay:   0.76 ms

Dynamic range:   115dB

Remote / Network 

Type: PC and PodWare Software

Connectors:    RJ45 female, RJ45 loop

Mechanical 

Cabinet Size (WxHxD):   730 x 586 x 1060mm

Cabinet finish:   Black epoxy painted

Rigging:   EasyFlighing AP rigging system

Protective grill:   Removable perforated 1,6mm steel, foam cover inside

Weight:   98Kg

Elements & Accessories 

DLA6

Dolly

Pdf 
Galerie 

(1) Frequency response: +/- 3sd, measured at 3 meters, on axis, half-space conditions -  MLSSA 1/3 octave

(2) Max peak SPL: Measured with music referred to 1 meter

(3) Crossover: Acoustical crossover frequency - at these frequency, transducers produce equal sound pressure level

(4) AES: Power handling is measured under AES standard conditions

(5) Power AMPS: Amplifier RMS output power per channel into 2 ohms, both channel driven